The system is preassembled on a common backplate and includes a control unit CU382, the water parameter sensor(s) with cable(s) to the control unit and the hydraulic assembly.
CU 382 control unit:
- Intuitive plain-text operation
- Data logger functionality (settings, calibration data and measured values)
- Up to 3 controller outputs, freely assignable
- Modbus (slave)
- Modbus sensor interface
- Data interchange with USB stick
- Wide-range power supply
Water parameter sensors:
- Modbus interface to CU 382 control unit
- Onboard storage of calibration data
- Temperature measurement and compensation included for all sensors
- Pre-calibrated (pH, ORP, conductivity sensor)
- Diaphragm-covered amperometric sensor principle for disinfectant sensors
- Low pH dependency for free-chlorine sensors
Flow cell and hydraulic assembly:
- Max. pressure at inlet: 3 bar Inlet/outlet hose connections suitable for hose sizes: 4/6mm, 6/9mm, 6/12mm, 9/12mm, xx/1/4″, 1/4″ x 3/8″, 3/8″ x 1/2″
- Shut-off valve
- Flow restrictor (limits to max. approx. 60l/h)
- Flow switch (activated at approx. 30l/h)
- Flow cell with sample water withdrawal assembly
- Max. pressure on outlet: 0,5 bar
This configuration includes:
| Sensors | Free Chlorine, Total Chlorine, PAA, Hydrogen peroxide, Ph, Redox, Conductivity |
| Sensortype | Sensor(s) with plug |
| Cable length | 1,0 m, plugs on both ends |
| Allowable liquid temperature range | 5-45 °C |
| Voltage indications | 100-240 V |
| Power consumption max.) | 33 VA |
| Protection level of control unit / sensor(s) | 65/67 |
The controller CU 382
The control unit CU 382 is intended for monitoring and control of disinfectants, pH, ORP, conductivity and temperature.
- Intuitive plain-text operation
- Data logger functionality (settings, calibration data and measured values)
- Up to 3 controller outputs, freely assignable
- Modbus (slave)
- Modbus sensor interface
- Data interchange with USB stick
- Wide-range power supply
- Multiple languages